Add the Saddlebag Car Clips (Fig 1) to the side straps of the Rightline Gear Cargo Saddlebag to attach the carrier to vehicles WITHOUT a roof rack (Fig 2).
Add The Saddlebag Car Clips To The Side Strap
Place the Cargo Saddlebag top side up. Extend one of the long side straps out. Make sure the strap is not twisted (Fig 3 and Fig 4).
Remove the male buckle from the strap. Make sure the other parts are positioned as shown (Fig 5).
Add the Saddlebag Car Clip and the male buckle onto the strap (Fig 6). Make sure the strap goes through the correct side of the buckle (Fig 6 Close-Up).
Run the strap back through the buckle, the Saddlebag Car Clip, the pad, and the tri-glide (Fig 7).
Repeat all steps for the second long side strap.
Attach The Saddlebag Car Clips To The Vehicle
Place the Saddlebag Car Clips in the gap between the vehicle’s rear hatch door and roof (Fig 8). Make sure the protective pads are face down on the top rear corner of the vehicle (Fig 9). Buckle the long side straps into the short side straps (Fig 10), testing that the buckle is fully engaged.
Please see the Cargo Saddlebag Set Up Guide for additional instructions.